Dremel Tile Spiral Cutting Bit (2615056232)

Dremel Tile Spiral Cutting Bit (2615056232)

Features and Specifications

- Our powerful tile cutting tool is ideal for shaping ceramic wall tile around bathroom or kitchen fixtures or plumbing pipes
- And if you're feeling creative, you can even use the tool to create a decorative design in your tiles
- Just use the tile cutting bit to carve your design, like a sailboat, then fill the grooves with colored grout
- Cuts ceramic wall tile, cement board, and plaster (not for use on floor tile)
- A high-speed cutter with a 1/8" steel shank
- Great for contractors
- High-speed cutter mounted on a 1/8 in. Steel shank
- Bit diameter mm: 3.2mm
- Overall length: 1.5mm
- Tile cutting bit shank diameter: 0.125

How to use it?

- We recommend using this bit with the Dremel tile cutting attachment because it’s designed to help you maintain depth during the application.
- It’s important that the depth of the guide supports the cutting blade extending beyond the material by about 0.6 cm. (.25”).
- If the bit extends out too far beyond the material, it can be more difficult to control and can actually snap the bit.
- Best control of the bit occurs when moving in a clockwise direction. Begin the cut at a 45-degree angle and then bring the accessory to 90 degrees.
- The tool should be set at a high speed, the feed rate of the material or the tool through the material should be slow and gradual.
- Too much pressure will cause this accessory to get “red hot.”
- Using the tip of the bit is not the best way to cut – we recommend using the sides of the bit, where the full cutting capacity of the fluting can be put to use.

Multi-tools

- Dremel 4000 (4000-4/65 ez)

- Dremel 8220 (8220-5/65)

- Dremel 8220 (8220-1/5)

- Dremel 4000 (4000-1/45)

- Dremel 8220 (8220-2/45)

- Dremel 3000 (3000-15)

- Dremel 3000 (3000-1/25 ez)

- Dremel 3000 (3000-2/25)

- Dremel 4300 (4300-3/45ez)